Digital BW, The Print

I installed the UT inks and had the same problem. I kept running nozzel checks that went from ok to almost no ink. Finally occurred to me to make very sure that I had tightly sealed off the top of both cartridges with tape. I redid the tape across the top as a precaution. After quite a few more cleanings  and  nozzle checks to get out all the air bubbles I had introduced, very nice nozzel checks.  And then, viola! My 1160 prints are just as Paul Roark described. Best of luck on this.

mediaworks2003 <centralny121@...> wrote:I just got the MIS UT inks and they actually produce a neutral B&W, 
however, the prints I am getting are high contrast, too light and 
media gray where they should be close to dark gray. I have tried 
Paul's UT workflow and curves and, using no curves.

Any suggestions most welcome. It's the first ink I have tried that 
doesn't look brown or purple so I'd love to get the settings right.

Thanks,
Bill


Yahoo! Groups SponsorADVERTISEMENT

Please visit the Group Homepage to check the Files, Bookmarks, Polls and other resources as they are often being updated. The page is at:

http://groups.yahoo.com/group/DigitalBlackandWhiteThePrint

If you wish to receive no emails or just a daily digest, or you wish to unsubscribe, please edit your Membership preferences by visiting this same page.

Please follow these basic guidelines:
- Include your full name with your message.
- Include the address of your website, if you have one.
- As threads develop, trim off excess portions of earlier messages to keep them short.
- As the topic of a thread changes remember to change the subject header.
- Good manners are required at all time. No personal attacks or flames
- Complete your Yahoo profile.
- Before posting a question, search the message archives and the various resources on the homepage. 




Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



---------------------------------
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software

[Non-text portions of this message have been removed]