I'd appreciate any suggestions on the best way to convert an Epson 3800 to pieziography. Assuming no ink clogs at present with the regular inks--- I have purchased a set of empty cartridges and a set of peiziography inks. My main question is whether it is better to flush the lines first with the peizoflush solution or should I simply install the piezigraphy ink set with the new cartridges and let these inks flush out the old inks with a few test prints.
If it is better to flush out the lines first, do I first fill all the new cartridges with the flush solution, and then remove this and refill them with the new inks? Is is possible to full drain these cartridges?
thanks very much
Jordan