Casio CZ/ VZ/ FZ - Pro Series

Just to clarify, I read your message #652, which gives this instruction:

"VR4 on the main board #MA1M, located on the upper right of the board. Fully
counter clockwise for maximum sensitivity, and clockwise for 
less sensitivity."

That description is a bit technical for someone who has never serviced a
synth, like me.  I assume you're talking about disassembling the synthesizer
with a screwdriver, then turning some sort of knob located on the
motherboard?  

Are there precautions that would need to be taken when doing this (for
someone who has never opened up a synthesizer), in order to avoid damage to
the synth or -- probably a far-fetched concern -- electric shock?

Jeremy



-----Original Message-----
From: Terry [mailto:orbitaldecay@hotmail.com] 
Sent: Tuesday, March 04, 2003 9:58 PM
To: CZsynth@yahoogroups.com
Subject: [CZsynth] Re: OT: AZ-1 MIDI controller

I posted the adjustment on the CZ-1 in message #652. Just a trimmer
adjustment. Someone with the same complaint had reported this fixed