AVR-Chat

thormj wrote:

> Anxious to try the new toys, I tried programming the "LEDs&Switches" 
> into the ATMega that came with the stk-500.  When I did this, it 
> asked to upgrade the firmware on the stk-500...
> 
> After finding a screwdriver (ahem... IC Puller), and removing the 
> target and jumpers, I held down the prog button while powering up, 
> and it seemed to be programming ok....
> 
> Except, I got a "Program Failed" message at the end.  Now AVR 
> Studio's avrprog doesn't recognize it...
> 
> Hrm... I'm actually not sure if its "all the way" dead -- the status 
> sometimes goes red-yellow-green if I reset the pc.
> 
> If it matters, I'm using a Belkin USB->serial adapter (which I 
> thought would work if it detected the STK firmware rev; stupid 
> Toshiba with no serial ports)...
> 
> I'll try with a "real" serial port Friday...
> Any tips on getting this back to working (or at least to where it 
> was)?
> 
> Thanks,
> Thor Johnson


Did you try the proccess using a dos box and running the dos program 
"AVRprog.exe" it is located in
"C:\Program Files\Atmel\AVR Tools\AvrProg" (if you installed in the 
default place. just before running it, make sure the STK500 is plugged 
into the serial port (and IIRC it is in program mode (no jumpers, target 
uC, deafult links, powered up with the prog button held)

Regards,

Kat.


-- 
---------------------------------------------------------------
K.A.Q. Electronics	Website: www.kaqelectronics.dyndns.org
IM: Yahoo: PinkyDwaggy  MSN: katinka@kaqelectronics.dyndns.org
For Everything Electronics     Phone: 0419 923 731
---------------------------------------------------------------	


-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.12/75 - Release Date: 17/08/2005