AVR-Chat

----- Original Message ----- 
From: arhodes19044
To: AVR-Chat@yahoogroups.com
Sent: Sunday, April 10, 2005 2:12 PM
Subject: [AVR-Chat] Re: Problem using MAKE



Running MAKE from DOS?  Oh, Oh.  In XP (home), all that I can do, as
far as I know, is open a DOS box.  I do not think that I can  drop
into raw DOS the way I could in 98.

Isn't a DOS box good enough?

I did get a DOS box to come up and I can CD to the demo directory.
From there I can issue the MAKE command.  MAKE does run, but says it
can not see the makefile.  Of course the Makefile is right there in
the current directory.

Why would this be?

It does not even like the "clean" arg to follow the MAKE command.

I am a little mystified.


Just open a DOS box, that's what I do.

Here's what I get:

C:\WinAVR\examples\demo>make clean
rm -rf *.o demo.elf *.eps *.png *.pdf *.bak
rm -rf *.lst *.map *.hex *.bin *.srec

C:\WinAVR\examples\demo>make
avr-gcc -g -Wall -O2 -mmcu=atmega8    -c -o demo.o demo.c
avr-gcc -g -Wall -O2 -mmcu=atmega8  -Wl,-Map,demo.map -o demo.elf demo.o
avr-objdump -h -S demo.elf > demo.lst
avr-objcopy -j .text -j .data -O ihex demo.elf demo.hex
avr-objcopy -j .text -j .data -O binary demo.elf demo.bin
avr-objcopy -j .text -j .data -O srec demo.elf demo.srec
avr-objcopy -j .eeprom --change-section-lma .eeprom=0 -O ihex demo.elf 
demo_eepr
om.hex
avr-objcopy -j .eeprom --change-section-lma .eeprom=0 -O binary demo.elf 
demo_ee
prom.bin
avr-objcopy -j .eeprom --change-section-lma .eeprom=0 -O srec demo.elf 
demo_eepr
om.srec

C:\WinAVR\examples\demo>

Leon
--
Leon Heller, G1HSM
http://www.geocities.com/leon_heller