AVR-Chat

>
>As you can program and verify, and the fuses looks good, what else is left
>but a code problem.
>Try read out the code from the working board and program that on the other
>two.

The AVRISP that I tired first had an ERROR and couldn't read the chip.
Mulltiple tries, restarts etc.
The Jtag is reading it.

Hex looks sane, got an int vector table, and some code anyway.

Switched boards, could NOT program the target with the same Jtag that 
pulled the program from the working board.
So, I switched to the AVRISP, which is now programming the board that the 
Jtag wouldn't.

Well, that was short lived, it had an ERROR while programming.

I really wish I had some information beyond "IT DIDNT WORK." when it fails.