AVR-Chat

After looking at my reply and your stuff again 
I think shift in must be ADC analog to digital converter. On my Atmega
128 this would be done on port F. Sorry if I and not be of more help
because I have not done anything with that yet.
 

-----Original Message-----
From: wbounce [mailto:wbounce@safeplace.net] 
Sent: Tuesday, March 01, 2005 10:17 PM
To: AVR-Chat@yahoogroups.com
Subject: RE: [AVR-Chat] Sharp Distance sensor: GP2D02 and an AVR



Variable are declared like 
uint8_t val02,i;

Pins on AVR are like 
PINA1
My AVR has ports A through G

The For would look like
For(i=0;i < 100; i++)
	{
	}

I have no idea what 
  SHIFTIN dt, cl, MSBPOST, [val02]
does. 

-----Original Message-----
From: Honea [mailto:fredit@charter.net] 
Sent: Tuesday, March 01, 2005 7:26 PM
To: AVR-Chat@yahoogroups.com
Subject: [AVR-Chat] Sharp Distance sensor: GP2D02 and an AVR



I am trying to convert some bs2 code for my distance sensor to work in C
for 
my AVR.

Here is the sensor and bs2 code.
http://www.acroname.com/robotics/info/examples/GP2D02-4/GP2D02-4.html

'--------------------------------------------------------
' variable declarations

val02 var byte ' value where reading is stored
i var byte ' count variable for loop


'--------------------------------------------------------
' constant declarations

cl con 14 ' pin 14 is output (clock)
dt con 15 ' pin 15 is the input (data)


'--------------------------------------------------------
' I/O pin setup for detector

INPUT dt ' make pin 15 the input
HIGH cl ' make pin 14 output and high


'--------------------------------------------------------
' main loop

DEBUG "Start", CR ' indicate beginning

FOR i = 1 TO 100 ' take and display 100 readings
  GOSUB read02 ' call measurement routine
  DEBUG dec val02, CR ' display the value
  PAUSE 100 ' stall so display readable
NEXT

DEBUG "Finish" ' indicate end

END ' stop Stamp when done


'--------------------------------------------------------
' subroutine read02
'
' This subroutine takes a reading from the connected
' GP2D02 detector and stores the value in "val02".
' Any two pins can be used.  Set "dt" to the data line
' of the GP2D02 (pin 4 on JST connector, yellow wire).
' Set cl to the clock line of the GP2D02 (pin 2 on the
' JST connector, green wire).

read02:
  LOW cl ' turn on detector for reading
  rl:
  IF IN15 = 0 THEN rl ' wait for input high
  SHIFTIN dt, cl, MSBPOST, [val02]
  HIGH cl ' turn detector off
  PAUSE 1 ' let detector reset
RETURN


-------------------------------------------------------------

Basically, I just need to know the gnu equal of this command: "  SHIFTIN
dt, 
cl, MSBPOST, [val02]"


Or if anyone has working code for this sensor, that would be great too
:)


thanks!
Lee





 
Yahoo! Groups Links



 






 
Yahoo! Groups Links