AVR-Chat

Page 74 of the complete data sheet along with table 35 (next page) covers
this topic pretty well. Pay particular attention to the table.

Cheers!

-----Original Message-----
From: ethan@bufbotics.org


Hello,

I am trying to figure out from the ATtiny26 datasheet whether I can use
PB0 & PB2 as I/O pins while using PWM outputs on PB1 & PB3.

Can anybody please shed some light on this?  I'd hate to lose two extra
I/O pins when using PWM.

I am planning on using PB1 & PB3 to drive the power setting of two motors
(via an H-bridge chip), and I need two other output pins to control the
direction of the motors.

Any thoughts?

Thanks, Merry Christmas & Happy New Year!!

Ethan
www.bufbotics.org