AVR-Chat

Gyuri Szing wrote:
> Hi All!
> 
> This is my first mail to this mailing list and thus please let me write a few lines introduction firs.
> 
> My name is György Szing and I am writing from Hungary (a small country in Central Europe). I have a degree in electrical engineering and I am a working in the automotive industry as an embedded software engineer.
> 
> I joined this list because of two reasons. My current project is to port communication software to ATMEGA88 and I have encountered a problem which I can not mange to solve, and I  have came to like this MCU family and plan to use it later for my hobby projects.
> 
> So I would like to ask you for help because I can not manage to program the fuse bits of the ATMEGA88. I have an STK500 board and a JTAGICE mk II.  I can not remember what I have done to the device but when I received them fuse programming worked fine. Later I configured it to allow debugging with the JTAGICE mk II: enabled debug wire interface, and configured to use a 8 MHz external crystal. Everything went fine till now. Now I should use the internal RC oscillator, but I realised that I can not program any of the fuses even in high voltage parallel programming mode (using the STK500 and RS232). I can change the protection bits, I can erase the device, I can download any program into the flash, I can run and debug the downloaded program but I can not change any fuses.
> 
> Does anybody have an idea what could cause this problem, and how could I solve it? I really need that on chip RC oscillator. 
> 
> Best regards:
>     Gyuri

Try programming it at the slowest clock speed.