AVR-Chat

im nt using ISP with g540 i just have these two options for programing
i hv programed atmega88 dip using g540 but its nt working

 
Best Regards
Sania Safdar




________________________________
 From: Jim Wagner <wagnerj@proaxis.com>
To: AVR-Chat@yahoogroups.com 
Sent: Saturday, January 21, 2012 9:39 PM
Subject: Re: [AVR-Chat] avr programming
 
The G540 does NOT work with ISP. You have to remove the mcu from your circuit and put the mcu in the programmer. ISP is "In System Programming" and works with an ISP programmer and your application board.

Further, if you look on the list of supported devices, here:

http://www.pic16.com/soft/G540_DeviceList.txt

There is no Atmel mega or avr chip even listed. It WILL program Atmel programmable logic devices and memory, but no MCU. So, even though the heading to the product says:

G540 USB Universal Programmer for EPROM FLASH GAL AVR PIC 51

Either that headline is lying or the device list is lying. Based on the list of supported devices, this device is totally useless for any atmel mcu.

Jim Wagner
Oregon Research Electronics

On Jan 21, 2012, at 8:24 AM, sania safdar wrote:

> g540 and ISP
> 
>  
> Best Regards
> Sania Safdar
> 
> ________________________________
> From: Zack Widup <w9sz.zack@gmail.com>
> To: AVR-Chat@yahoogroups.com 
> Sent: Saturday, January 21, 2012 8:47 PM
> Subject: Re: [AVR-Chat] avr programming
> 
> 
>  
> What programmer are you using?
> 
> Zack
> 
> On 1/9/12, shirin ghanbari <shivarin12@yahoo.com> wrote:
> >
> >
> >
> > I program the fuse bits of the avr mega under 1.5MHZ external crystal and
> > then i can not program it it . chip enable error
> > please help me what can i do?
> >
> > [Non-text portions of this message have been removed]
> >
> >
> 
> [Non-text portions of this message have been removed]
> 
> 



[Non-text portions of this message have been removed]



------------------------------------

Yahoo! Groups Links



[Non-text portions of this message have been removed]