Synth-DIY Yahoo! Groups Archives

Using Balanced Cables with AN1x

2013-09-05 by <william.bromell@...>

Does the AN1x accept TRS cables without any problem? I'm trying to connect the unbalanced outputs to a balanced input (XLR). I could get a TS to XLR cable, but it would be easier to just use TRS to XLR.

Re: [AN1x] Using Balanced Cables with AN1x

2013-10-18 by jammie

the only problem is a -10dbu signal on a +4 so the signal will be a lot quieter than if using a balanced signal

also if the an1x output uses common ground for its output ground you can get noise earth loop from the connected balancing equipment unless its a floatin system via a balancing trafo which it does not mater

----- Original Message -----

From: william.bromell@...

To: AN1x-list@yahoogroups.com

Sent: Thursday, September 05, 2013 8:37 AM

Subject: [AN1x] Using Balanced Cables with AN1x

Does the AN1x accept TRS cables without any problem? I'm trying to connect the unbalanced outputs to a balanced input (XLR). I could get a TS to XLR cable, but it would be easier to just use TRS to XLR.

No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4158 / Virus Database: 3614/6755 - Release Date: 10/16/13