Hi Shakti,
Years ago, most headphones were 8 ohms, and all headphone outputs on stereos, etc. were set up to handle this load. These days, headphone impedances are all over the place, from around 30 ohm to tens of thousands of ohms.
Regards,
-BW
--
Bruce Wahler
Ashby Solutions™ http://music.ashbysolutions.com
978.386.7389 voice/fax
bruce@...
>Thanks for the reply Jimmy!It could be a combination of the AN1x and the headphones you are using. I use a pair of Sennheiser HD580's, and while the volume is adequate, it's not overly loud. I was prepared for this: All of the reviews said that the Sennheisers really need a strong amp to drive them, because of their high impedance.
>
>> Are all the patches quiet or just some?
>
>All patches are low in volume.
>
>What are you using for an amp?
>
>I have been using headphones ( a couple different types)
Years ago, most headphones were 8 ohms, and all headphone outputs on stereos, etc. were set up to handle this load. These days, headphone impedances are all over the place, from around 30 ohm to tens of thousands of ohms.
Regards,
-BW
--
Bruce Wahler
Ashby Solutions™ http://music.ashbysolutions.com
978.386.7389 voice/fax
bruce@...