The Yamaha AN1x Synthesizer mailing list

Right I managed to sort it out so I can control the SW1k HPF cut off using my AN1x
assign knobs & NRPN's:

In Cubase Open the List edit for appropriate track, choose ins. Control Change from 
thedrop down menu.

Choose the pen Tool,

Insert event & choose Cntrl #99 NRPN MSB (value always 1) {This is telling the HW to use an NRPN}

Insert event & choose Cntrl #98 NRPN LSB (specifies one parameter with a number; 
cf. NRPN table)  {This is specifying which NRPN -in this case 36 for HighPassFilter} 

Then

Insert event & choose Cntrl #6 MSB Data Entry (value of parameter specified in #98; 
default val always 64,range 0-127) 

But I omitted this last stage & instead set the ANix's assign knob 4 too contoller 
6 data MSB,to control value range (Note the SW1k HPF 0...64...127 = -64...0...+63 so control 
isnt very fine.)

And it worked!!

If any ones gotta better solution...

P
----- Original Message ----- 
From: Peter Scullion 
To: AN1x-list@yahoogroups.com 
Sent: Saturday, November 02, 2002 7:12 PM
Subject: AN1x - SW1k control?


Hello All,

I would like to control the high pass filter cutoff of my SW1000xg soundcard, using the AN knobs, but thier seems to be no way of using CC's to control this parameter, is thier a way around this?

If this is not possible, I understand I can use NRPN's within my sequencers (Cubase) list editor but am not sure how to implement this...?

Any advice appreciated

Thanks in advance

Pete


[Non-text portions of this message have been removed]