The Yamaha AN1x Synthesizer mailing list group photo

Yahoo Groups archive

The Yamaha AN1x Synthesizer mailing list

Index last updated: 2026-04-28 22:40 UTC

Message

Re: [AN1x] Farfisa?

2002-05-02 by Scott Carr

Bruce,

Thanks alot - this was very helpful!

Scott

Bruce Wahler wrote:
> 
> Hi Scott,
> 
> >I've been tewaking around with a couple of organ patches trying to come
> >up with an authentic Farfisa sound to no avail. Anyone have a few
> >patches of this ilk lying around that they'd be so kind as to post to
> >the files section for reference?
> 
> I don't have a Farfisa for my AN1x, because all of my pianos and other claviers are programmed on my Alesis S4.  However, I can give you the recipe for the sound, as I used all analog-synth waveforms in creating it:
> 
> 1.  You'll need to use Dual mode on the AN1x, as you will need 3-4 oscillators to program the sound.  Program three oscillators to start:  16' (Course Pitch = -12), 8' (0), and 4' (+12).
> 
> 2.  Use narrow pulse waves for the basic sound, running from about 33% on the 4' (and 2', if needed) to ~15% on the 16' settings.  Set them up with no detune or PWM and a reasonably strong Edge setting; start with ~110.  If you are looking for a "Multi-Tone Boost" kind of Farfisa sound, then narrow the waves by 25%.
> 
> 3.  The output level of the oscillators should taper off very slightly from 16' up; try 16' = 127, 8' = 122, 4' = 117 for starter.  The VCF should be wide open, or nearly so.
> 
> 4.  The low end on a Farfisa is mediocre.  You can simulate this by using the HPF to roll off a bit of bass.  Use your ear as a guide, or do the following:  Turn down all the oscillators except the 16', and adjust the HPF until lowest 1-2 notes on the AN1x are almost inaudible.
> 
> 5.  Add vibrato to taste.  I found it most useful to use a knob or the mod wheel to add it.  The vibrato is a combination of pitch modulation and a tiny bit of PWM.  Standard combo organ vibrato is about 6Hz.  For extra credit, program an adjustable 4-6 speed knob, as Farfisas usually have a vibrato speed tab.
> 
> 6.  After playing around with the sound levels, pulse widths, and Edge settings, if the sound is still not "right," try adding a bit of 2' (+24) pitch, with the same pulse width as the 4' oscillator.
> 
> I hope this helps.
> 
> Regards,
> 
> -BW
> 
> --
> Bruce Wahler
> Ashby Solutions\ufffd   http://music.ashbysolutions.com
> CloneWheel Support Group moderator
> 978.386.7389  voice/fax
> bruce@...
> 
> 
> Community email addresses:
>   Post message: AN1x-list@yahoogroups.com
>   Subscribe:    AN1x-list-subscribe@yahoogroups.com
>   Unsubscribe:  AN1x-list-unsubscribe@yahoogroups.com
>   List owner:   AN1x-list-owner@yahoogroups.com
> 
> Shortcut URL to this page:
>    http://groups.yahoo.com/group/AN1x-list
> 
> 
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

-- 
~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%
  Visit the the home of Hebephrenic, The Hot Buttered Elves, & Sunshine

                     http://www.tapehissrecordings.com

         and our sites at the worlds largest online cut-out bin

                    http://mp3.com/hotbutteredelves
                      http://mp3.com/hebephrenica
                   http://mp3.com/sunshineallthetime
~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%~%

Attachments

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.