The Yamaha AN1x Synthesizer mailing list

--- In AN1x-list@y..., "Jake B" <drummer@p...> wrote:
> ok another addition to the problem.  I went to use my an1x last 
night and
> tried the normal outputs and to my amasement they worked fine.  I 
used it
> for about an hour and a half and then the problem started happening 
again.
> Hooked it up to the headphones and all was happy again.  So it 
sounds like
> it is heating up or something and then cutting out.

This is conspicuously similar to the behavior exhibited with 
the "old" problem of audible 'popping and clicking' sound at start-
up - until the unit reached a normal operating temperature (jokes and 
comparison to a REAL analog will ensue...) I'm speculating, i.e., not 
fact - just opinion, that the problem with your AN1x is related to 
the other known problem.

Of course, I could be wrong. ;-)

Did you reinitialize your AN1x as suggested? This has been known to 
clear seemingly random acts of strange behavior in the AN1x. Isn't 
the key command '7+8+9' while powering the unit up? Then it should 
prompt you with a selection of init options - just choose ALL and 
reply YES.

Peter K. - if you're following this thread - what was the weirdness 
your AN1x displayed. Didn't you have something along these lines or 
just the 'popping & clicking' problem?

> 
> any other ideas?
> 
> jake


regards,

Jon