The Yamaha AN1x Synthesizer mailing list

Jim,

>How would I use a dual configuration...do you mean two scenes? Could you 
>(It's fine if you don't feel like it..I know this kind of thing is time 
>consuming to write, and it's always hard to know how ignorant I am :-) go 
>into a little more detail? Just some of the key settings, especially 
>routing and hooking up of the modules? THis is where I get stuck...and I 
>am nowhere near "up to speed" yet on these.

Exactly.  If you press both of the Scene buttons at the same time, you get 
into what I was calling "dual" mode.  At that point you have four 
oscillators, two VCAs, two VCFs, etc.  If you dedicate one of the scenes to 
"normal" synth sounds -- set the noise level to "0" -- and the other one to 
just noise and filtering -- turn the VCO1, Ring Mod, and VCO2 levels all 
the way down -- the noise source can be adjusted independent of the VCOs.

>Getting no sleep whatsoever :-)

Been there, done that!  ;^)

Regards,


-BW

--
Bruce Wahler
Design Consultant
Ashby Solutions"
www.ashbysolutions.com
CloneWheel Support Group moderator
978.386.7389  voice
978.776.0096  fax
bruce@...