The Yamaha AN1x Synthesizer mailing list

Well I stand corrected! Thank you Gary :-)

Jon

--- In AN1x-list@y..., "Gary Gregson" <gary@y...> wrote:
> Jon wrote:
> >>
> Are you certain? On my AN1x every effect parameter is clearly marked in
> Hz, kHz, db, ms or s. What point does the LFO Frequency table serve
> then?
> <<
> 
> The table on p8 is there to allow you to construct sysex messages for effect
> parameters i.e. so that you know which data byte value to send for a
> specific LFO value. (its not there so that you can understand the values
> from the front panel....since the synth has the lookup table built in, it
> kindly displays the effect values in the correct units on the front panel).
> AN1xEdit does exactly the same thing.
> 
> However the actual LFO module of the AN voice generator i.e. LFO 1 & 2 (not
> the effects) simply displays LFO SPEED values in the range 1 - 256. Yamaha
> have not provided a lookup table to translate these values into Hz. Again
> An1xEdit behaves the same way (since I was unable to obtain from Yamaha what
> the corresponding frequency values are!).
> 
> Regards
> 
> Gary
> Email:
>      gary@y...
>      http://www.yme.co.uk/yme