the only problem is a -10dbu signal on a +4 so the
signal will be a lot quieter than if using a balanced signal
also if the an1x output uses common ground for its
output ground you can get noise earth loop from the connected balancing
equipment unless its a floatin system via a balancing trafo which it does not
mater
----- Original Message -----From: william.bromell@...Sent: Thursday, September 05, 2013 8:37 AMSubject: [AN1x] Using Balanced Cables with AN1xDoes the AN1x accept TRS cables without any problem? I'm trying to connect the unbalanced outputs to a balanced input (XLR). I could get a TS to XLR cable, but it would be easier to just use TRS to XLR.
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4158 / Virus Database: 3614/6755 - Release Date: 10/16/13