mandala_73 a écrit :
voltage" level a bit too high. This should have been corrected in the
last one. When the backup voltage is really too low you can face random
(and unwanted) patch changes at each turn on of the synth.
If everything gets lost, don't panic and perform a "full factory reset"
as explained in the manual. OK, your own patches are gone with the wind,
but you can play again...and program new ones.
Cheers.
J.F.
> When I checked the old battery that I had removed from the AN1X, itSomeone said it depends on the OS release, earlier ones have a "low
> still read as borderline good on my voltage meter but apparently my
> AN1X will show the "low battery" message when powering up if the
> battery isn't well into the good 3 volt range.
voltage" level a bit too high. This should have been corrected in the
last one. When the backup voltage is really too low you can face random
(and unwanted) patch changes at each turn on of the synth.
If everything gets lost, don't panic and perform a "full factory reset"
as explained in the manual. OK, your own patches are gone with the wind,
but you can play again...and program new ones.
Cheers.
J.F.