Hi,
I don't have midi connected on my AN1x. The only cables connected are
the power supply, headphones and line outputs.
Cheers
Arthur
--- In AN1x-list@yahoogroups.com, Alex Baumann <pctech333@...> wrote:
>
> I think the suggestion to disconnect everything but power and audio
may be a good one. Try this for a little while, because one
possibility is that something in your midi chain is sending it
controller data like volume and cutoff. Do you think that is
possible?
>
> Alex
>
> ----- Original Message ----
> From: Arthur Alexander Crichton <ac010b4919@...>
> To: AN1x-list@yahoogroups.com
> Sent: Thursday, February 14, 2008 9:10:01 AM
> Subject: [AN1x] Re: Sound problems with AN1x
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> I have tested my AN1x with just the headphones
connected and the
>
> problem seems to have disappeared. I then tested with the line
>
> outputs connected and still there is no problem. Finally I tested
>
> with the headphones and line outputs both connected and again no
>
> problems.
>
>
>
> The problem seems to have disappeared.
>
>
>
> Could it be that...
>
>
>
> 1) I pressed the "assign" button while powering on the synth that
>
> fixed the problem
>
>
>
> or
>
>
>
> 2) My AN1x is temperamental?
>
>
>
> Cheers
>
>
>
> Arthur
>
>
>
> --- In AN1x-list@yahoogrou ps.com, "Arthur Alexander Crichton"
>
> <ac010b4919@ ...> wrote:
>
> >
>
> > Haha its been along time since someone has called me Alex:) Ok, I
>
> > have removed the left and right line outputs and left the
>
> headphones
>
> > in. So far the problem has disappeared. I will disconnect the
>
> > headphones and connect the line outputs and see if the problem
>
> > returns.
>
> >
>
> > I'll report back if there is any probems.
>
> >
>
> > Cheers
>
> >
>
> > Arthur
>
> >
>
> >
>
> > --- In AN1x-list@yahoogrou ps.com, Jeff <jf.serviere@ > wrote:
>
> > >
>
> > >
>
> > > Hello Alex!
>
> > > as you describe your problem it looks like something wrong in
the
>
> > analog output circuit: dry solder joint, bad contact or
some "ill"
>
> op
>
> > amp or transistor that goes out when hot. The heat related
failure
>
> is
>
> > probable because it works well for a short time and after the
sound
>
> > decreases, a contact problem would occur more irregularly. I'm
not
>
> at
>
> > home currently, so i cannot open mine to tell you what to look
and
>
> > where. I don't think it is a fatal issue at all, but it could
take
>
> a
>
> > long time to find the faulty part.
>
> > > You can try 2 things without opening the synth:
>
> > > First remove all additional devices (effects, patch bay..)
>
> between
>
> > the AN1x and the amp or mixer.
>
> > > Then turn on your synth with the line out plugged only,play it,
>
> > > and after do the same thing without line out but with
headphones
>
> > only.
>
> > > If you're using a mixer try another input with the line out
>
> > connected.
>
> > > Look (or more likely hear !) if there is some difference.. ..
>
> > > Cheers
>
> > > J.F.
>
> > >
>
> > >
>
> > > > Message du 14/02/08 00:42
>
> > > > De : "Arthur Alexander Crichton"
>
> > > > A : AN1x-list@yahoogrou ps.com
>
> > > > Copie à :
>
> > > > Objet : Re: [AN1x] Sound problems with AN1x
>
> > > >
>
> > > > > Ok, I tried a factory reset and played the affected sounds
>
> > again and
>
> > > > it seemed to fix the problem. Then I leave my AN1x on and 5
>
> > minutes
>
> > > > later the problem comes back:(
>
> > > >
>
> > > > What will I do? Is my AN1x ready for the synth graveyard in
the
>
> > sky?
>
> > > >
>
> > > > Please advise
>
> > > >
>
> > > > Arthur
>
> > > >
>
> > > > --- In AN1x-list@yahoogrou ps.com, "Arthur Alexander
Crichton"
>
> > > > ...> wrote:
>
> > > > >
>
> > > > > How do I reload the OS?
>
> > > > >
>
> > > > > Is it the same as a factory reset? If so, I did a factory
>
> reset
>
> > but
>
> > > > > the problem still persists.
>
> > > > >
>
> > > > > The problem is when I keep the key pressed the sound just
>
> > abruptly
>
> > > > > goes dull and low in volume which it shouldn't do. Its like
>
> the
>
> > > > > cutoff has gone to "0" and the main volume has gone low.
>
> > > > >
>
> > > > > Cheers
>
> > > > >
>
> > > > > Arthur
>
> > > > > --- In AN1x-list@yahoogrou ps.com, nung242 wrote:
>
> > > > > >
>
> > > > > > I would try backing up your patches, then maybe reload
the
>
> > OS. It
>
> > > > > worked for a problem I was having on my K-Station. Good
Luck!
>
> > > > > >
>
> > > > > > http://www.youtube. com/tillthenmusi k See the AN1x in
>
> > > > > action on the song " legend "
>
> > > > > >
>
> > > > > > Arthur Alexander Crichton >
>
> > > > > wrote: Hi,
>
> > > > > >
>
> > > > > > I have a problem with my Yamaha AN1x.
>
> > > > > >
>
> > > > > > When I select some pad sounds on my AN1x the sounds are
>
> > bright
>
> > > > and
>
> > > > > > after about 3 seconds the sound just cuts off to a duller
>
> > sound
>
> > > > > which
>
> > > > > > is very low in volume. When I press the keys again all I
>
> get
>
> > is
>
> > > > a
>
> > > > > > faint dull sound. I try to play the keys harder but I
still
>
> > get
>
> > > > > this
>
> > > > > > sound. Before I had this problem, those paticular patches
>
> > used
>
> > > > to
>
> > > > > > sound bright and full. Also, I have noticed some sounds
>
> sound
>
> > > > > thinner
>
> > > > > > than what they used to and that sounds that rely on
>
> arpeggio
>
> > or
>
> > > > > lfo
>
> > > > > > sound muddy and strange.
>
> > > > > >
>
> > > > > > What is wrong with my beloved AN1X?
>
> > > > > >
>
> > > > > > I have tried cleaning the control knobs with switch
cleaner
>
> > but
>
> > > > I
>
> > > > > > still get the same problem. BTW the rom version on my
AN1x
>
> is
>
> > > > v1.02
>
> > > > > >
>
> > > > > > Please help.
>
> > > > > >
>
> > > > > > Arthur
>
> > > > > >
>
> > > > > >
>
> > > > > >
>
> > > > > >
>
> > > > > >
>
> > > > > >
>
> > > > > > ------------ --------- --------- ---
>
> > > > > > Never miss a thing. Make Yahoo your homepage.
>
> > > > > >
>
> > > > > > [Non-text portions of this message have been removed]
>
> > > > > >
>
> > > > >
>
> > > >
>
> > > >
>
> > >
>
> > >
>
> > > [Non-text portions of this message have been removed]
>
> > >
>
> >
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> <!--
>
> #ygrp-mkp{
> border:1px solid #d8d8d8;font-family:Arial;margin:14px
0px;padding:0px 14px;}
> #ygrp-mkp hr{
> border:1px solid #d8d8d8;}
> #ygrp-mkp #hd{
> color:#628c2a;font-size:85%;font-weight:bold;line-
height:122%;margin:10px 0px;}
> #ygrp-mkp #ads{
> margin-bottom:10px;}
> #ygrp-mkp .ad{
> padding:0 0;}
> #ygrp-mkp .ad a{
> color:#0000ff;text-decoration:none;}
> -->
>
>
>
> <!--
>
> #ygrp-sponsor #ygrp-lc{
> font-family:Arial;}
> #ygrp-sponsor #ygrp-lc #hd{
> margin:10px 0px;font-weight:bold;font-size:78%;line-height:122%;}
> #ygrp-sponsor #ygrp-lc .ad{
> margin-bottom:10px;padding:0 0;}
> -->
>
>
>
> <!--
>
> #ygrp-mlmsg {font-size:13px;font-family:arial, helvetica, clean,
sans-serif;}
> #ygrp-mlmsg table {font-size:inherit;font:100%;}
> #ygrp-mlmsg select, input, textarea {font:99% arial, helvetica,
clean, sans-serif;}
> #ygrp-mlmsg pre, code {font:115% monospace;}
> #ygrp-mlmsg * {line-height:1.22em;}
> #ygrp-text{
> font-family:Georgia;
> }
> #ygrp-text p{
> margin:0 0 1em 0;}
> #ygrp-tpmsgs{
> font-family:Arial;
> clear:both;}
> #ygrp-vitnav{
> padding-top:10px;font-family:Verdana;font-size:77%;margin:0;}
> #ygrp-vitnav a{
> padding:0 1px;}
> #ygrp-actbar{
> clear:both;margin:25px 0;white-space:nowrap;color:#666;text-
align:right;}
> #ygrp-actbar .left{
> float:left;white-space:nowrap;}
> .bld{font-weight:bold;}
> #ygrp-grft{
> font-family:Verdana;font-size:77%;padding:15px 0;}
> #ygrp-ft{
> font-family:verdana;font-size:77%;border-top:1px solid #666;
> padding:5px 0;
> }
> #ygrp-mlmsg #logo{
> padding-bottom:10px;}
>
> #ygrp-vital{
> background-color:#e0ecee;margin-bottom:20px;padding:2px 0 8px 8px;}
> #ygrp-vital #vithd{
> font-size:77%;font-family:Verdana;font-weight:bold;color:#333;text-
transform:uppercase;}
> #ygrp-vital ul{
> padding:0;margin:2px 0;}
> #ygrp-vital ul li{
> list-style-type:none;clear:both;border:1px solid #e0ecee;
> }
> #ygrp-vital ul li .ct{
> font-weight:bold;color:#ff7900;float:right;width:2em;text-
align:right;padding-right:.5em;}
> #ygrp-vital ul li .cat{
> font-weight:bold;}
> #ygrp-vital a{
> text-decoration:none;}
>
> #ygrp-vital a:hover{
> text-decoration:underline;}
>
> #ygrp-sponsor #hd{
> color:#999;font-size:77%;}
> #ygrp-sponsor #ov{
> padding:6px 13px;background-color:#e0ecee;margin-bottom:20px;}
> #ygrp-sponsor #ov ul{
> padding:0 0 0 8px;margin:0;}
> #ygrp-sponsor #ov li{
> list-style-type:square;padding:6px 0;font-size:77%;}
> #ygrp-sponsor #ov li a{
> text-decoration:none;font-size:130%;}
> #ygrp-sponsor #nc{
> background-color:#eee;margin-bottom:20px;padding:0 8px;}
> #ygrp-sponsor .ad{
> padding:8px 0;}
> #ygrp-sponsor .ad #hd1{
> font-family:Arial;font-weight:bold;color:#628c2a;font-
size:100%;line-height:122%;}
> #ygrp-sponsor .ad a{
> text-decoration:none;}
> #ygrp-sponsor .ad a:hover{
> text-decoration:underline;}
> #ygrp-sponsor .ad p{
> margin:0;}
> o{font-size:0;}
> .MsoNormal{
> margin:0 0 0 0;}
> #ygrp-text tt{
> font-size:120%;}
> blockquote{margin:0 0 0 4px;}
> .replbq{margin:4;}
> -->
>
>
>
>
>
>
>
>
>
______________________________________________________________________
______________
> Never miss a thing. Make Yahoo your home page.
> http://www.yahoo.com/r/hs
>
> [Non-text portions of this message have been removed]
>Message
[AN1x] Re: Sound problems with AN1x
2008-02-14 by Arthur Alexander Crichton