Hello Lou ! when i assign the mod wheel as i've described previously the sounds changes "continuously" between both scenes . It's like having a balance pot . Of course when the wheel is fully up or down you will hear only scene 1 or scene 2 ; a foot pedal will do the same . Scene select must be done by a simple push button , just as the switches on the front panel . @+ J.F. lou.kadassy a \ufffdcrit : >I'm not sure it will work (I've not tried yet because I don't have a >momentary switch handy). However, the transition you're talking about >should still take place when I change the switch state from ON to OFF: >I chose an on/off switch simply because I don't want to keep a pedal >pressed all the time. > >I tried assigning MW to SceneSel and I noticed that when the MW is at >zero the first scene gets selected, moving it about halfway selects >the second scene and moving it all the way up selects both scenes. So >I suspect that a continuous controller (and a certain amount of foot >dexterity) might be necessary. >Anyone has first-hand experience on this? > >Thanks very much for your help, >Lou > > >--- In AN1x-list@yahoogroups.com, Jeff <jf.serviere@...> wrote: > > >>>I'm using an "on/off" switch, maybe a temporary one (sustain pedal >>>type) will do the trick? >>> >>> >>> >>YES ! OF COURSE ! Because the hardware inside your synth is "waiting >>for" an edge (transition between the "1" and "0" state or the opposite) >>, not a logic level (1 or 0) to toggle between the 2 scenes . Take a >>look at all the buttons on the front panel : they are all momentary >>switches . >>@+ >>J.F. >> >>lou.kadassy a \ufffdcrit : >> >> >> >>>--- In AN1x-list@yahoogroups.com, "Jon" <jondl_2000@> wrote: >>> >>> >>> >>> >>>>--- In AN1x-list@yahoogroups.com, "lou.kadassy" <lou.kadassy@> wrote: >>>> >>>> >>>> >>>> >>>>>I thought it would be easy to use a footswitch to, ahem, "switch" >>>>>between scenes, but I haven't been able to do that. >>>>> >>>>>My question is: can I use a foot switch (or continuous foot >>>>>controller, aka volume pedal) to switch between scene 1/2? I don't >>>>>want to morph, I just need to switch. >>>>> >>>>>Any help would be appreciated. >>>>> >>>>>Lou >>>>> >>>>> >>>>> >>>>> >>>>Yes, to both. >>>> >>>>On the AN1x, set the [EDIT ROTARY] Knob to the UTILITY/SETUP menu. >>>> >>>>Press Ctrl Device until you see FS displayed. >>>> >>>>Press Ctrl No to change the value to 3: SceneSel >>>> >>>>Press Ctrl Device until you see SCENE displayed, the Ctrl No value >>>> >>>> >>>> >>>> >>>should also be 3: >>> >>> >>> >>> >>>>SceneSel. If it's not, press Ctrl No to change the value to 3: >>>> >>>> >SceneSel. > > >>>>Play your sound, presee the Foot Switch (FS) to hear the 2nd Scene, >>>> >>>> >>>> >>>> >>>release to hear the 1st >>> >>> >>> >>> >>>>Scene. There is no Morphing invoked when using FS. >>>> >>>>Repeat the above procedure for using a Foot Controller (FC). >>>> >>>> >>>> >>>> >>>Obviously, Morphing can be >>> >>> >>> >>> >>>>used with FC and you can have both FS and FC available >>>> >>>> >>>> >>>> >>>simultaneously. Might get >>> >>> >>> >>> >>>>confusing if you use the AN1x as a Master Control Keyboard ;-) >>>> >>>>Hope this helps. >>>> >>>>Regards, >>>> >>>>Jon >>>> >>>> >>>> >>>> >>>> >>>Jon, >>>many thanks for your response. >>> >>>Unfortunately, it doesn't work as I expected. Did all the steps but >>>when I press the switch *both* scene lights go on and I listen to a >>>mix between the two. >>>I'm using an "on/off" switch, maybe a temporary one (sustain pedal >>>type) will do the trick? >>> >>>Thanks again, >>>Lou >>> >>> >>> >>> >>> >>> >>>Community email addresses: >>> Post message: AN1x-list@yahoogroups.com >>> Subscribe: AN1x-list-subscribe@yahoogroups.com >>> Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com >>> List owner: AN1x-list-owner@yahoogroups.com >>> >>>Shortcut URL to this page: >>> http://groups.yahoo.com/group/AN1x-list >>> >>>The AN1x Control Synthesizer FAQ:: >>> http://www.geocities.com/jondl_2000/an1x_faq/an1x_faq_toc.htm >>> >>>Yahoo! Groups Links >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>--------------------------------------------------------------------------------------- >> >> >>>Orange vous informe que cet e-mail a ete controle par l'anti-virus >>> >>> >mail. > > >>>Aucun virus connu a ce jour par nos services n'a ete detecte. >>> >>> >>> >>> >>> >>>--- >>>avast! Antivirus: message Entrant propre. >>>Base de donn\ufffdes des virus (VPS): 0637-1, 13/09/2006 >>>Test du: 14/09/2006 18:08:19 >>>avast! - copyright (c) 2000-2006 ALWIL Software. >>>http://www.avast.com >>> >>> >>> >>> >>> >>> >>> >>> >> >> >>--- >>avast! Antivirus: message Sortant propre. >>Base de donn\ufffdes des virus (VPS): 0637-1, 13/09/2006 >>Test du: 14/09/2006 19:18:25 >>avast! - copyright (c) 2000-2006 ALWIL Software. >>http://www.avast.com >> >> >> > > > > > > >Community email addresses: > Post message: AN1x-list@yahoogroups.com > Subscribe: AN1x-list-subscribe@yahoogroups.com > Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com > List owner: AN1x-list-owner@yahoogroups.com > >Shortcut URL to this page: > http://groups.yahoo.com/group/AN1x-list > >The AN1x Control Synthesizer FAQ:: > http://www.geocities.com/jondl_2000/an1x_faq/an1x_faq_toc.htm > >Yahoo! Groups Links > > > > > > > > > >--------------------------------------------------------------------------------------- >Orange vous informe que cet e-mail a ete controle par l'anti-virus mail. >Aucun virus connu a ce jour par nos services n'a ete detecte. > > > > > >--- >avast! Antivirus: message Entrant propre. >Base de donn\ufffdes des virus (VPS): 0637-1, 13/09/2006 >Test du: 14/09/2006 23:54:33 >avast! - copyright (c) 2000-2006 ALWIL Software. >http://www.avast.com > > > > > > --- avast! Antivirus: message Sortant propre. Base de donn\ufffdes des virus (VPS): 0637-1, 13/09/2006 Test du: 15/09/2006 07:50:03 avast! - copyright (c) 2000-2006 ALWIL Software. http://www.avast.com
Message
Re: [AN1x] Re: Using a foot for scene switching?
2006-09-15 by Jeff