Archive of the former Yahoo!Groups mailing list: Yamaha CS80

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [yamahacs80] Re: CS60 PSU issue

From: Andrew Kirkby <kirkbyte@...>
Date: 2011-07-16

ok,

So, all keys up until the top D key work fine. If i press a single key
above top D i get no sound whatsoever BUT if i hold a key below the
top D key and one above at the same time it will produce the note
below top D correctly and the note above with lots of distortion and
the wrong pitch.

If i press 8 keys located below the top D key, all voices work fine so
i know it's not an issue with a M board.

I have checked the ICs on the lower boards and have found some strange
behaviour on IC12 of the KAS board (4016). If i measure the voltage
between ground and pins 8 or 9 while pressing a low key on the
keyboard, i get a small voltage (1-3 volts) on the meter. If i press a
key above that D key i get a negative voltage around -4.5 volts. No
lower key press gives a negative voltage.


Andrew


On 16/07/2011, at 5:19 AM, Quazimodo wrote:

> That don't make sense... can you explain it better Andrew..!
>
> "...unless a key from an octave below it" ...?
>
> --- In yamahacs80@yahoogroups.com, Andrew Kirkby <kirkbyte@...> wrote:
> >
> > I now have another problem on the top octave now - i can't get any
> > sound unless a key from an octave below it, then i get crazy sounds
> > without correct pitch. Looks like a morning on the scope is
> needed :)
> >
> > AK
> >
>
>
>

Andrew Kirkby
(e) kirkbyte@...
(m) 0416 000 070






[Non-text portions of this message have been removed]