Archive of the former Yahoo!Groups mailing list: Yamaha CS80

On my CS-80, I have one bad voice and have checked the VCO chip (IG00153) output from pin 7 with an oscilloscope and it looks fine. However, on the IG00158 waveshaper I don't get output from pin 2 or 5 and an extremely low amplitude wave from pin 7. With this particular voice, there is a tuned, very low level, high band frequency sound (a buzzing) that responds to velocity, the suboscillator, aftertouch, VCF, VCA, etc., so I think the circuit is good after the waveshaper. I've ordered a new IG00158 chip, hoping that replacing it will fix the problem. Is there anything else I should check? I'm planning on soldering in a socket to push the chip into. Any recommendations? Can I just pick up a 16-pin socket from Radio Shack?