10,000 bulbs... how you gonna off-load them...!? Now, if they were 10,000 VCO chips.... well, a different kettle of silicone...;c)
Cheerz,
TOM
--- In yamahacs80@yahoogroups.com, "Mike" <mborish_2000@...> wrote:
>
> Ok, So I got the first models in and they are close but not quite the same, I think. There is a voltage drop of about 100mv more than the originals and they are slightly brighter and whiter - this is very subtle. They also run a tiny bit hotter. It could be that the ones in my CS-80 are old and don't have the output that they had when they were new. I have tested the new ones extensively and they seem OK. The IG00157 doesn't get hot either.
>
> Does anybody know anything about the IG00157? What are the specs? If the specs confirm that these bulbs are OK, then we are good to go and I can order a couple thousand.
>
> Also, before I make a move, there is another bulb model that I want to check out first because it could be a better fit; it draws a third less current and has a third less lumens. Unfortunately, I might need to order 10,000 of them and wait 3 months. Ha Ha
>
> Any comments or suggestions will be appreciated.
>
> -Mike
>
> --- In yamahacs80@yahoogroups.com, "Mike" <mborish_2000@> wrote:
> >
> > I finally cross referenced the preset bulbs to the exact specifications of the originals - same shape, lumens, wire leads, filament type, etc. I'm going to buy a bunch of them if the samples check out ok that I ordered. Is anybody interested in preset bulbs?
> >
>