honestly, i MUCH prefer just leaving the entire assembly down and tuning that way. i also seem to get a bit more accuracy with it down. using a static wristguard and a plastic tuning piece, i just gently push the wiring above up a little. works fine for me. good luck.
--- On Sun, 4/5/09, omegacode80 <omegacode80@...> wrote:
From: omegacode80 <omegacode80@...>
Subject: [yamahacs80] Raising circuit board rack for tuning
To: yamahacs80@yahoogroups.com
Date: Sunday, April 5, 2009, 11:50 AM
Hi Everyone,
After mastering the M-board tuning procedure on my CS-50 I am now
ready to tackle the tuning procedure for my CS-80.
Can anyone provide pointers on how to safely raise the circuit board
rack in to the "tuning" position? I don't see a procedure for doing
this in the service manual.
Cheers,
Kent
New York, NY
[Non-text portions of this message have been removed]