Hi,
My PWM Works !!! my problem was a network resistors ... after replace, it's work fine !
I have another questions :
for PW calibration, on service manual Page 19 / Paragraph 4.2 :
"2) Adjust VR3 to obtain +2.2v"
I obtain +2,2v but i no longer sounds if the potentiometer on the front between 7 and 10, Is this normal?
Thanks,
Richard
--- In PolySix@yahoogroups.com, Jed Jorgensen <jed.jorgensen@...> wrote:
>
> Hi folks,
>
> I was dealing with a sick kid yesterday and didn't have time to take a good
> photo until just now.
>
> ∗http://tinyurl.com/985qtwc∗
>
> I have uploaded this photo to my website for posterity.
>
> I hope this helps. It is surprisingly hard to take a photo of a shiny PCB
> like this. (Especially while trying to keep a 4 year happy.)
>
> Best regards,
>
> Jed
>
> On Sun, Sep 9, 2012 at 2:42 AM, del_poolp <del_poolp@...> wrote:
>
> > ∗∗
> >
> >
> > Hi,
> >
> > I have a problem with PWM, i don't have output.
> >
> > On KML367 On IC15, pin 1, i don't have waveform output, just a 2.2v
> > signal, and on IC20 pin 5 don't have a waveform output, just linear output
> > (~1v). (i have compared with functionnal Polysix )
> >
> > I'm lost, i don't know where to look for solve the problem. If you have an
> > idea ?
> >
> > You have a Hight-quality photo of PCB (no populated), the photo on Jed
> > Jorgensen website is poor quality and it's too hard to read the component
> > value ?
> >
> > Thanks, Richard
> >
> > PS : Sorry for my english
> >
> >
> >
>
>
> [Non-text portions of this message have been removed]
>