They are both 10K resistors but the original was a 1 percent tolerance part
and the clone just calls for a 5 percent part.
Old - Brown, Black, Black, Red
New - Brown, Black, Orange
Don B.
_____
From:
PolySix@yahoogroups.com [mailto:
PolySix@yahoogroups.com] On Behalf Of
mopedsimi
Sent: Monday, December 05, 2011 5:25 PM
To:
PolySix@yahoogroups.comSubject: [PolySix] Resistor R10: correct value?
Hi, I just joined the group. Splendid platform in any case!
I just finished two replacement KLM-367 clones and
have some problems though. At the moment I'm still
working on the elemination of simple reasons for that.
(wrong resistor values, bad solder points etc.)
As I have compared the original Board with the clone, I've
discovered that Resistor R10 on the clone (and in the part list)
has a different value to the one on the original.
Clone and part list says 10 kOhm but the original one is 120 Ohm.
I'm not shure if that was done on purpose?
[Non-text portions of this message have been removed]