I think those chips are all socketed, so you could ∗∗∗CAREFULLY∗∗∗
swap the chips around and see if the problem follows. When you open
the case, you can tell which voice is sounding by the LED. Find out
which one is bad, then swap it with another.. One chip at a time.
Make sure the system is turned off for a couple minutes before you
pull or insert a chip. The chips used are not easy to get, but
possible.
On 5/25/07, blacknred123 <blacknred123@yahoo.co.uk> wrote:
> Hi firstly thanks for your reply secondly do you think its easily
> sorted i.e. is there much chance of me picking up an EG chip for
> replacement assuming that is the problem!?!?
>
>
>
> --- In PolySix@yahoogroups.com, klosmon <klosmon@...> wrote:
> >
> > First impression is that one of the envelope generators is not
> working.
> > Possibly the EG chip itself; possibly the support circuit.
> >
> > ~G
> >
> > At 06:49 AM 5/25/2007, you wrote:
> >
> > >Hi all I just recieved my polysix aware that it had a problem it
> seems
> > >that every 6th note i play no mater where it is on there board it
> cuts
> > >out, But only in poly mode. The key does not sound when i have the
> > >switch set to eg on the VCA but when switched to wave on the vca
> the
> > >sixth note whatever it may be is muffled. Does anyone have any
> > >ideas!?! Bearing in mind that the batt has never been changed i
> > >wodered if this may have something to do with it though all buttons
> > >lights etc work as they should!??!......will be changing batt this
> week!
> > >
> > >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
>
> PolySix "Digiest" Page: http://www.acc.umu.se/~amber/Poly6
> Yahoo! Groups Links
>
>
>
>
--
.sig
-Chromatest J. Pantsmaker
http://www.chromatest.net