Hi Ben-
Your draft looks pretty darn good! I agree with David, the outer ribs run all the way from the bottom flange to just below the top edge. The sides & tops of the ribs are rounded, if possible.
The crack I noticed was isolated to the middle of the cover body, across the area where the tension ring locates, and may have been there already. Thanks for the offer of a cap, though!
The description of the cap Mr. Leete describes would be a "bayonet" mount (similar to BNC connectors and many automotive light applications). This makes me wonder if there were production variations in the switch/cap combo, and might be worth researching.
It is amazing your printer is capable of reproducing something this small with accuracy. I look forward to the results.
-Bruce Daily
#1221
--------------------------------------------
On Fri, 7/28/17, David Ub ultraboreal@gmail.com [newmellotrongroup] <newmellotrongroup@yahoogroups.com> wrote:
Subject: Re: [newmellotrongroup] 3d printed M400 power cap
To: newmellotrongroup@yahoogroups.com
Date: Friday, July 28, 2017, 2:33 AM
Please read "less than 1mm from top
of the cap", just to be clear!