Hello,
yes it is possbile/available !
but u need to select CC mode 2 on the AN1x
(page 96 of the plain manual 'control change modes')
and then check page 9 of the data list manual
vco1 midi CC 78 Pulse width
vco1 midi CC 79 PWM depth
vco2 midi CC 55 Pulse width
vco2 midi CC 56 PWM depth
Regards
--------------------------------------------------Env1-----Env2--Env3-----------
Andrea.TONI@... Vco1 \ | | \
Solar-Terrestrial Missions (Sci-Sh) Vco2-->--Vcf-->Vca-->Ducati996
www.rssd.esa.int Vco3 / | | /
--------------------------------------------------Lfo1-----Lfo2--Lfo3-----------
Sorry, I just recognised that I picked the wrong table, it wasn't the CC table,
so Pulswidth isn't avaiable via a predefined controller... :( But it's still
possible to route the Pulswidth to Mod-Wheel, Aftertouch or one of the other
avaiable CC# by using the control-matrix...
On 7 Feb 2006 at 23:55, digitaldisko wrote:
> can I do this with a simple midi keyboard with a few buttons to
> store programs?
If it supports channel pressure or having a mod-wheel, even pitch pend can be
used, if you don't need the controller otherwise...
> Will I be able to tell how much I have changed the
> pulse-width once I start to adjust the parameters?
Depends on your entry in the control-matrix, direct control or just a certain
amount. Since you have to set it for every preset you use, you can decide what
works best for the sound...
...Summa