--- In
AN1x-list@yahoogroups.com, "digitaldisko" <digitaldisko@y...> wrote:
>
> You were right Jon about putting it in PLG mode in the AN1xEdit
> program. Now it works fine. Which is a very good sign.
That's great!
> I followed
> your advice and also downloaded the latest driver for my US 122.
> But I am still having trouble doing a bulk dump in the AN Expert
> Editor. I go to setup -> Recieve AN1x Bulk Dump. Is this the right
> operation since I have a AN 200?
It should be, yes. Unless there is some funky SysEx header I'm not aware of that
differentiates an AN200 from a PLG150-AN
> There are two other options that
> are not in bold which are: Insert AN Bulk Dump Data.. and Extract
> Bulk Dump Data.. . Is that what I want or should I follow up on my
> problem with the "recieve AN1x bulk dump".
I do not know what the Insert and Extract Bulk dump Data commands are - they do not
appear in the Mac version of AN Expert Editor (at least not that I see.)
Tell me - have you been able to initiate a bulk from AN1xEdit? If you haven't, then I would
advise you try and upload a single Voice from your AN200 to AN1xEdit. Since you are able
to successfully transmit from AN1xEdit to your AN200 then the reverse should hold true.
Please double check the MIDI Ch and Device No settings on your AN200 match those used
to in both AN1xEdit and AN Expert Editor. I'm fairly certain the PART No. and Board default
values of '1' are okay, but please double check the doc from your AN200 and verify the
settings on your hardware match those in your software, Probably a good idea to have the
PART No. and MIDI CH set the same, but again - I'm uncertain how the AN200 handles the
Board value.
If it works successfully with AN1xEdit then we know it is not a connectivity issue with the
US-122, but rather a configuration issue with AN Expert Editor.
Jon