--- In
AN1x-list@yahoogroups.com, "digitaldisko" <digitaldisko@y...>
wrote:
>
> Thanks Jon that was a BIG help!
>
> I have always felt there was things that were happening in the
> presets of my synth that I didn't have control over. Then I looked
> in the manual at the AN200 editor section and saw all the things I
> was looking for: VCO1/2 pitch and fine tune, PWM controls, key
> tracking, etc. But unfortunately the reason I never opened up this
> program on my computer is because I get an error each time I try to
> open it. On the disk I received when I bought my AN200, I open up
> the XGworks folder and install the program. Then I restart my
> computer and install the AN200 editor program/plugin. But when I
go
> to start the program I get a "Error: XGworks.exe - Entry Point not
> found (the procedure entry point FT_Exit4 could not be located in
> the dynamic link library KERNEL32.dll) My operating system is
> Windows XP home edition. Is there an update or any advice people
> could give me in order to run this program on my computer?
There is a patch available from Yamaha to correct the error you
describe. Go to XG Factory at
http://www.xgfactory.com/then navigate to the Downloads page, and then to the Yamaha link.
Chose the update approprate to your system. I don't run XGWorks, but
if you have difficuties with the patch post back to this list or try
the DX200 list also here at Yahoo! Groups as they have much
experience with this patch.
Also,
> what does PEG, FEG, AMOD, and FMOD stand for?
I assume you've read Jimmy's reply by now. I would suggest you check
out the Links section as there are links to many synth programming
tutorials including some specific to the AN200:
http://launch.groups.yahoo.com/group/AN1x-list/linksJon
Jo