--- In
AN1x-list@yahoogroups.com, "pro52man2003" <pro52man2003@y...> wrote:
> Hello everyone...
>
> I am interested in using my AN1x to control soft synths such as
> Pro52, FM7 and B4 within Cubase 5.1
>
> I am able to map the 8 controller knobs to various paremeters in the
> Pro 52 by using the Ctrl device and Ctrl No buttons on the AN1x.
> These mappings are still in place when I reboot everything. OK so far.
>
So you are changint he Assign Knob values on the AN1x to match the CC's of the
Pro52, correct? There is CC Table available for download from NI that makes short
work of mapping CCs from AN1x->Pro52 - you might want to spend some time with
it to see if it makes your work more productive.
> However, if I now remap settings in B4 for instance, the mappings I
> made in the Pro52 are now altered and I have to remap them.
>
Okay, here's where I get lost - I interpret your 1st sentence to read you are updating
the CCs transmitted from the AN1x Assign Knobs but this implies you are remapping
CCs in B4. Which is accurate?
> What I want to be able to do is load a load of softsynths into Cubase
> and know that any mappings I programme will remain. Is this possible?
>
More than likely however, my experience is with Logic Audio not Cubase :-/ I would
urge you check out the Cubase Mixer Maps available for download here:
http://launch.groups.yahoo.com/group/AN1x-list/filesI don't think Reggie is still on the list to answer question on his mixer maps but you
might want to visit the forums at Cubase.net
> Similarly, it would be great to have control knobs set up for Reasons
> REX player and then have another setup for the Maelstrom synth. Is
> this possible or do I need a more specialised controller such as
> Edirol PCR or Novation remote etc.
>
> Finally, can mixer volumes be controlled via midi (AN1x)?
>
See above.
> Thanks in advance
>
> Pro52man2003
Jon