Hi,
>I am interested in using my AN1x to control soft synths such as
>Pro52, FM7 and B4 within Cubase 5.1
>
>I am able to map the 8 controller knobs to various paremeters in the
>Pro 52 by using the Ctrl device and Ctrl No buttons on the AN1x.
>These mappings are still in place when I reboot everything. OK so far.
>
>However, if I now remap settings in B4 for instance, the mappings I
>made in the Pro52 are now altered and I have to remap them.
>
>What I want to be able to do is load a load of softsynths into Cubase
>and know that any mappings I programme will remain. Is this possible?
>
>Similarly, it would be great to have control knobs set up for Reasons
>REX player and then have another setup for the Maelstrom synth. Is
>this possible or do I need a more specialised controller such as
>Edirol PCR or Novation remote etc.
I can't directly answer the Cubase questions, but I suspect that they are related to this next question. The AN1x has eight programmable knobs which can be mapped to any MIDI CC function, but the mappings are global; i.e., there is only one set of mappings for all 128 patches. If you want to map a bunch of controllers, and change the mappings for each soft-synth or application, I would suggest the Evolution UC-16, X-Stealth (UC-17), or UC-33e. These devices have a bunch of programmable knobs -- and in the case of the latter two, switches -- that can be re-programmed and stored in several locations. Thus, you would be able to save a set for B-4, another set for Pro-52, etc.
>Finally, can mixer volumes be controlled via midi (AN1x)?
Yes, if you put the synth into CC Mode 2 -- hold down the Assign button on power-up to check and set the mode -- then the AN1x responds to many additional parameters through MIDI CC, including:
VCO1 Level: CC#68
VCO2 Level: CC#69
Noise Level: CC#39
Ring Mod Level: CC#70
VCA Feedback: CC#63
Regards,
-BW
--
Bruce Wahler
Ashby Solutions™
http://music.ashbysolutions.com978.386.7389 voice/fax
bruce@...