Dmanx .. I am writing you 4th time...
Did you see my Reply on 9/14/2003 on AN1xMIDI thread ?
You seemed to be using AN1xEdit and Virtual MIDI port in a wrong way..
I didn't see any reply or ANY other notice that you read my Message-Reply on your question...
Ray.
----- Original Message -----
From: DMANX@...
To: AN1x-list@yahoogroups.com
Sent: Saturday, October 04, 2003 11:11 PM
Subject: [AN1x] An1x & cubase
Hi,
Please can someone very kindly tell me what the following parameter settings should be in An1x edit when using AN1X synth in cubase.My sw1000xg has a DX150PLG connected to it as well.
My stting on an1x and an1xedit is
Key TX = 2
Arp TX = 2
Rx1 = 2
Rx2 = 2
Device = 2
V.FX = Off
The problem Iam having is that I can not get the an1x to talk to the editor when using cubase.Some times if I click on a voice in an1xedit, my synth says reciving.. but its not the voice I had selected from an1xedit, soits not tranmitting back to my synth.I think its still using the std preset voices form an1x.
I know the setup must be a bit difrent when using the plg card (an150) I know there is documentation on this, but not for an1x using an1xedit in cubase?
Can some please advise me on my settings please.
Regards
Dmanx
--------------------
talk21 your FREE portable and private address on the net at http://www.talk21.com
Yahoo! Groups Sponsor
ADVERTISEMENT
Community email addresses:
Post message: AN1x-list@yahoogroups.com
Subscribe: AN1x-list-subscribe@yahoogroups.com
Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
List owner: AN1x-list-owner@yahoogroups.com
Shortcut URL to this page:
http://groups.yahoo.com/group/AN1x-list
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]