Hi Jimmy,
>What do I need to use the AN1x to control 2 synth modules?
A lot depends what you want the other modules to do.
Generally, though, I would turn Local Off, and connect the modules like so:
An1x Out --> Module 1 In
Module 1 Thru --> Module 2 In
Module 2 Thru --> An1x In
This way, the AN1x isn't automatically on all the time. Now set the AN1x Rx Channel to CH1, Module 1 to CH2, and Module 2 to CH3. Then use the An1x Tx Channel to switch between synths.
If you want to do more complex things (layering, splits), you might need to add some MIDI processors in the chain, depending on the setup you want. Contact me offline if you need more details.
Regards,
-BW
--
Bruce Wahler
Ashby Solutions™
http://music.ashbysolutions.com978.386.7389 voice/fax
bruce@...