--- In
AN1x-list@yahoogroups.com, jake@t... wrote:
> I was wondering how you get the midi in signal to go out the midi
out of the
> an1x. I have a kaysound 4902 controller which is ran into the midi
in of my
> an1x, then the output from the an1x goes to a m audio quattro midi
in port.
> The Tx channel on the an1x is on 1 and the kaysound is on 2.
>
> When assigning the midi channels to VSTis in Cubase SX I am only
getting the
> control from the an1x. If I plug the kaysound directly into the
quattro then
> the kaysound will work, but not if running through the AN1x.
>
> I am guessing there is a setting in the AN1x to allow midi input to
be echoed
> through the output.
>
> TIA,
> Jake
You need to use the MIDI Thru on the AN1x not the MIDI Out jack. Try
this setup instead:
KS4902 MIDI Out -> AN1x MIDI In
AN1x MIDI Thru -> Quattro MIDI In
Quattro MIDI Out -> KS4902 MIDI In
I'm uncertain what benefit there is running the KS4902 in series with
the AN1x - no doubt you have your reasons but it seems redundant to
me.
HTH.
Jon