--- In AN1x-list@y..., DMANX@t... wrote:
>
> Hi,
> I need to use my sw1000xg and plugin board for its on-board
midi sounds.And I need to use a low latency 24bit/96khz audio
card for soft synths and recording.My question is how would I
configure this in cubase so I can record the sw1000xg sounds
through this second audio card ?How should it be wired up? do i
need any extra gear?How do I connect my midi keyboard to
access these 2 cards.
If you don't get an answer here, check this Cubase specific
forum:
http://linux1723.dn.net/cgi-bin/ubb/forumdisplay.cgi?action=topics&forum=sound+cards&number=5&DaysPrune=10&LastLogin=
I would think you'd want to take the S/PDIF outfrom the SW1K
and route it to the 24/96 card S/PDIF input. You'll probably need
to set the clock rate on the 24/96 to match the SW1K but I
wouldn't see that as a problem. I can't see any benefit to
recording the output of the GM sound set at 96kHz ;-) Check your
manual for specific.
Jon
> Also the sw1000xg outputs it sounds at 24bit/44.1khz,so how
do mix it with sounds recorded from a 24bit/96khz audio card.
> Any advise please?
>
> Regards Dmanx.
>
>
>
> --------------------
> talk21 your FREE portable and private address on the net at
http://www.talk21.com