Archive of the former Yahoo!Groups mailing list: The Yamaha AN1x Synthesizer mailing list

Hi all,
I know it's been asked before but couldn't see any answers.
my prob is the following .

When assigning cut off to ribbon-X controller in the matrix control
routing, the ribbon position never acts the same.
according to the operation manual it should hold its position after
being released and not go center ( operation manual p75).
Well, at least in my case, it's not true, sometime the cutoff
assigned ribbon keeps its position sometimes it reset to center.
a few patches tend to be more "reset centered" than "held to the
their last ribbon position", but you never know.

When the performance goes through editing (neither-ribbon nor cuttof
related editings BTW) these "tendencies" might swap to one another.

Am I missing anything, has anybody noticed the same problem ?
thx for your help

fred