Hello,
I was trying to map all midi CC of the AN1X to the doepfer drehbank
yesterday night and I found a small misprint in the data list manual
page 9
CC 28 is sign as PEG sustain level
instead of FEG sustain level a bit confusing
but I am sure there is no PEG sustain so HAS to be the sustain of the ADSR
of the VCF
nicely enough the CC to map are 7 (all matrix page except assignable knobs)
x 8 .. 56 then .. and 8 are free (of the 64 possible assignable knobs on the
drehbank)
for REV send .. DLY send CHO send VOL PAN few extra not in the matrix
so will be nice to have them all 64 at once available ..
now the challenge and the hardest part is to study
a rational layout on the drehbank panel
and a useful graphics for the carton board that I will apply on top
with the parameters print .. pity the space in the drebank is so small
will be hard to write names and to draw logical connecting lines of
synth block modules (VCO VCF LFOs etc etc).. basically a control panel
like G.Gregson SW editor's scene .. but with real knobs )
I will keep u up to date :-)
Regards
-------------------------------------ENV1-----ENV2---ENV3--------------
Andrea TONI VCO1 \ | |
Solar System and Space VCO2-->--VCF--->VCA---->DUCATI 996
Science Division (SO) VCO3 / | |
-------------------------------------LFO1-----LFO2---LFO3--------------
email:
Andrea.Toni@... http://solarsystem.estec.esa.nl