In article <000001c11054$52f43d40$0200a8c0@bigpc>, Gary Gregson
<
gary@...> writes
>Reggie wrote:
>>>
>I knew it was a dump message, but in midiox the message starts 00 01 00
>01, not with the usual F0 or E0? So it was hard to find which message it
>was sending.
><<
>
>Huh? Sysex messages never start with E0...that's pitch bend!
That's why I put a question mark by it, I wasn't sure because the whole
string is missing in Midiox, I get around 490bytes of 00 01 then a load
of other data after it.
> It is
>possible to get a sysex continuation message (F7) ...but it's rarely
>used with modern systems.
>
>The message for the AN1x should start: F0 43 00 5C 0F 16 11
>For the PLG150AN the message should start: F0 43 00 5C 0E 28 20
>
>If MIDIOX is showing something different on your system, then you have a
>configuration problem in MIDIOX or whatever you are using as a pipe
>driver between An1xEdit and MIDIOX....in other words you are losing
>data!!!!
It would appear that hubi's is losing data then, oh, dear.
>
>Regards
>
>Gary Gregson
>
>Email:gary@...
>http://www.yme.co.uk/yme
>
>
>
>
>Community email addresses:
> Post message: AN1x-list@yahoogroups.com
> Subscribe: AN1x-list-subscribe@yahoogroups.com
> Unsubscribe: AN1x-list-unsubscribe@yahoogroups.com
> List owner: AN1x-list-owner@yahoogroups.com
>
>Shortcut URL to this page:
> http://groups.yahoo.com/group/AN1x-list
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
See ya,
Reggie