Tom wrote:
>>
I was wondering, I tried to change the LFO speed of ther An1X from
Cubase yesterday and it didn't work, I don't know wether i selected the
wrong channel or wether its the keyboard, does anyone have a complete
tried and tested list of these channels, which one for example changes
the speed of LFO1??? ( lost my manual)
<<
Err... you seem to be mixing up the terms 'channel' and 'controller'
For the An1x to receive controller data from the sequencer; it must be
configured to receive on the same MIDI channel that the sequencer is
using to send the data.
Thereafter it depends in which controller mode you are using the synth
and/or if you are using the voice Matrix.
IF you are in controller mode 1, then the An1x has no set controller for
altering LFO speed. However in controller mode 2 the AN1x uses:
CC14 LFO Reset
CC15 LFO Wave
CC16 LFO1 Speed
CC17 LFO2 Speed
Of course for each individual patch you can setup the MATRIX to map
almost any controller to LFO1/LFO2 Speed and LFO Delay (regardless of
controller mode!).
Regards
Gary Gregson
Email:
gary@...http://www.yme.co.uk/yme