--- In AN1x-list@y..., "Jake B" <drummer@p...> wrote:
> ok another addition to the problem. I went to use my an1x last
night and
> tried the normal outputs and to my amasement they worked fine. I
used it
> for about an hour and a half and then the problem started happening
again.
> Hooked it up to the headphones and all was happy again. So it
sounds like
> it is heating up or something and then cutting out.
This is conspicuously similar to the behavior exhibited with
the "old" problem of audible 'popping and clicking' sound at start-
up - until the unit reached a normal operating temperature (jokes and
comparison to a REAL analog will ensue...) I'm speculating, i.e., not
fact - just opinion, that the problem with your AN1x is related to
the other known problem.
Of course, I could be wrong. ;-)
Did you reinitialize your AN1x as suggested? This has been known to
clear seemingly random acts of strange behavior in the AN1x. Isn't
the key command '7+8+9' while powering the unit up? Then it should
prompt you with a selection of init options - just choose ALL and
reply YES.
Peter K. - if you're following this thread - what was the weirdness
your AN1x displayed. Didn't you have something along these lines or
just the 'popping & clicking' problem?
>
> any other ideas?
>
> jake
regards,
Jon