Hi Jerry,
>>
I understand that the pitch bend wheel is not covered by this chart.
That's cool, I can figure that one out. Do you think it would be a
reasonable interpretation if I assume that the 8 knobs, the mod wheel
and the ribbon controller(s), are described by the CC AT column? My
assumption is based on the fact they can all send CC's.
<<
Correct!
Alternatively if you use my An1xEdit application, the popup menus used
for parameters highlight entries that are not valid for selection based
on the current allocated control source!
Regards
Gary Gregson
Email:
gary@...http://www.yme.co.uk/yme