Hi!
Heres my set up as follows:
WIN98SE,PIII 450MHZ,midi keyboard,SBlive platinham,SW1000XG,PLG150AN,ASIO 2.5,Loopback drivers,Phatboy midi controller.
System set up regaring PLG150AN IS as follows:
xgedit:
midi in=none
midi outA= SWSYNTH 1
midi out B= SWSYNTH 2
midi thru= yes
PLG150AN EDIT:
midi in= none
midi out= LB1
CUBASE5 MME SETUP:
INPUTS:
sw midi in= enable
LB1= enable
LB2= enable
LB3= Disable
LB4= Disable
OUTPUTS:
swsynth 1 = enable
swsynth 2= enable
sw midi out= enable
LB1=Disable
LB2=Disable
LB3=enable
LB4=enable
IN Hubi hwmdcable.exe
INPUT= LB1
OUTPUT= swsynth 1
IN CUBASE 5:
Under VST OPTIONS/MIDI SETUP input drop down box LB1,LB2 is ticked.
In midi vst options ,midi filter...all record filter OFF,all thru boxes =off including sysex.
Play in background is checked in VST OPTIONS.
Now the following happens with the above setup.
1/I can only play 150an voices on midi chanel 1 in cubase5,when I assign other voices via 150AN through cubase to i.e chanel 3,4..etc i get no
sound,
only signal input/output in transport bar?Im trying to play/record various
voices on seperate midi chanels using 150an board,but can only get out put
on midi chanel1(sw synth1).Can only use 150AN voices on one midi chanel
only?I need to play back more then one midi chanel voices through plg150?
2/Using 150an edit with cubase5,I can not change voices or change
parameters,only get the same sound that was assigned in midi chanel 1 in
cubase5?How are the voices selected an parameters changed in 150an edit to
reflect it back to cubase5?
3/ I also tried using the setup procedure described in one of your download files 'HOW TO ACCESS THE PLG BOARD ON SW1000XG USING CUBASE'.This involved using 2 sequencers side by side ...cubase5 an SGWorks using the main plg 150an gui interface....IT SEEM TO WORK OK?But I would like to know the answer if possible of Item 2 above?
I would be gratefull if someone can advise me on these matters.
Thanx..dem
--------------------
talk21 your FREE portable and private address on the net at
http://www.talk21.com