Jim,
>How would I use a dual configuration...do you mean two scenes? Could you
>(It's fine if you don't feel like it..I know this kind of thing is time
>consuming to write, and it's always hard to know how ignorant I am :-) go
>into a little more detail? Just some of the key settings, especially
>routing and hooking up of the modules? THis is where I get stuck...and I
>am nowhere near "up to speed" yet on these.
Exactly. If you press both of the Scene buttons at the same time, you get
into what I was calling "dual" mode. At that point you have four
oscillators, two VCAs, two VCFs, etc. If you dedicate one of the scenes to
"normal" synth sounds -- set the noise level to "0" -- and the other one to
just noise and filtering -- turn the VCO1, Ring Mod, and VCO2 levels all
the way down -- the noise source can be adjusted independent of the VCOs.
>Getting no sleep whatsoever :-)
Been there, done that! ;^)
Regards,
-BW
--
Bruce Wahler
Design Consultant
Ashby Solutions"
www.ashbysolutions.com
CloneWheel Support Group moderator
978.386.7389 voice
978.776.0096 fax
bruce@...