Well, I have an sw1k, So I want to use the sustain for some of the
instruments and I want to use the Wah type pedal for FX send level or
whatever. I can run one from my Roland controller keyboard and the Wah
type I will run Via my peavey midi controller, that way I can assign it
to anything that takes any midi message, including sysex. I could even
control the DSPF with the Wah type pedal if I got bored enough!
Thanks for mentioning the Foot volume pedal, they guy in the shop wasn't
exactly clear about it!
I have never used either type of pedal before, but if anyone has any
other ways of using one let me know. (Yeah, yeah, I know foot up, foot
down, nothing to it!)
Would using it for after touch be viable?
Thanks again,
In article <
5.0.2.1.2.20010220162201.00a047b0@...>,
Bruce Wahler <
bruce@...> writes
>Reggie,
>
>>So, can anyone explain how to set up the 2 types of foot thing I will
>>buy tomorrow?
>
>It depends what you want to do with them. Typically, you'll put the "wah"
>type pedal into the Foot Volume jack, and the sustain pedal into the Foot
>Switch jack. (You could also use the Foot Controller jack for the wah
>pedal.) Then go to the CTRL functions using the buttons and rotary switch
>on the AN1x, or AN1xEdit, and set the FV (or FC) controller to the MIDI CC#
>that you want. Usually, volume is CC#7, expression is CC#11, and CC#6 is
>the data slider. Then set the FS controller in the same manner; sustain is
>CC#64, portamento is CC#65, soft pedal is CC#66, sostenudo is CC#67. An
>example is on pg96-97 in the manual.
>
>Actually, you don't need to follow conventions if you're setting the device
>at the other end of the chain to the same CC#. The only caveat is that if
>you set the CC# to something that has a name on the display, rather than
>'------', it's going to affect the AN1x directly -- this might be good or
>bad, depending on the setup.
>
>Regards,
>
>-BW
>
>--
>Bruce Wahler
>Design Consultant
>Ashby Solutions"
>www.ashbysolutions.com
>CloneWheel Support Group moderator
>978.386.7389 voice
>978.776.0096 fax
>bruce@...
>
>
>
>Community email addresses:
> Post message: AN1x-list@onelist.com
> Subscribe: AN1x-list-subscribe@onelist.com
> Unsubscribe: AN1x-list-unsubscribe@onelist.com
> List owner: AN1x-list-owner@onelist.com
>
>Shortcut URL to this page:
> http://www.onelist.com/community/AN1x-list
>
See ya,
Reggie