Archive of the former Yahoo!Groups mailing list: The Yamaha AN1x Synthesizer mailing list

previous by date index next by date
previous in topic topic list  

Subject: Re: [AN1x] Using Balanced Cables with AN1x

From: "jammie" <jammie.emma@...>
Date: 2013-10-18


the only problem is a -10dbu signal on a +4 so the signal will be a lot quieter than if using a balanced signal
 
also if the an1x output uses common ground for its output ground you can get noise earth loop from the connected balancing equipment unless its a floatin system via a balancing trafo which it does not mater
----- Original Message -----
From: william.bromell@...
To: AN1x-list@yahoogroups.com
Sent: Thursday, September 05, 2013 8:37 AM
Subject: [AN1x] Using Balanced Cables with AN1x

 

Does the AN1x accept TRS cables without any problem? I'm trying to connect the unbalanced outputs to a balanced input (XLR). I could get a TS to XLR cable, but it would be easier to just use TRS to XLR. 

No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4158 / Virus Database: 3614/6755 - Release Date: 10/16/13