Gary Osborne wrote:
> Are 850Mhz CPU's too fast for Hubi's (16bit) and Midi Yoke(32bit)
> therefore causing some of the data to get lost or truncated?
No...the speed of CPU is irrelevant....its only software.
>>
Because I have been battling to get the PLG150AN to load up properly going
on 2 months now. So far I've got it down to this ...With An1xEdit in
PLG150AN mode, An1xEdit using Hubi's LB1 out.... an instance of hwmdcabl.exe
with LB1 in ...SW1000XG#1 out. I double-click a voice from the
"Yamaha_Best_Of.an1" voice list, I either get no sound or a completely
different sound from the intended sound. I can verify this by choosing
SW1000XG#1 as the output of AN1xEdit ...double-click any voice and it sounds
correct.
<<
The problem here is not the virtual drivers (Hubis/MIDIYoke) but the
application that is thruing the data between the virtual driver and the real
SW1000 driver. The sysex messages used by AN for voice dumps include some
very large packets (around 4 Kbytes). However most software apps use small
sysex buffers (around 512 -> 2K bytes) for MIDI thru. The result is that the
larger messages get discarded or corrupted! Hence the voice corruption.
The solution would be to increase the sysex buffer size used for thruing
sysex in your application (unfortunately very few applications provide such
control...although MIDIOX does)
That said, the version of Hubis Hwmdcable.exe I use (V2.3) appears to work
fine.
However in your case I would question why you are using the Hwmdcable.exe at
all. Since the latest SW1K drivers are multiclient for output (only), you
should be able to just connect your sequencer and An1xEdit directly to
SW1000#1 without a conflict problem.
The only reason I can think of is that you are maybe attempting to overcome
the sysex thru bug of Logic 4.x :-(
Regards
Gary
Email:
gary@...http://www.yme.co.uk/yme > -----Original Message-----
> From: Gary Osborne [mailto:gosborn1@...]
> Sent: 02 August 2000 00:50
> To: AN1x-list@egroups.com
> Subject: [AN1x-list] OK ...I'm Stumped...PLG150AN + An1xEdit +Hubi's
> issues...Help Please