Hi,
Thanks but, as I said, it's not a matter of note stealing, the sound stops entirely while i'm playing the poly single presets.
I've already restored the factory settings and the problem persists. I don't get a battery low message, no.
Cheers,
Alex
--- In AN1x-list@yahoogroups.com, Jeff <jf.serviere@...> wrote:
>
> alexandros_vagenas a écrit :
> >
> > Hi everyone,
> >
> > This is my first post here as I just got a used An1x.
> >
> > When I first turned it on and started going through the presets, I
> > realised that on the poly single sounds, after I had played a few
> > notes, there was a gap when no sound would be produced when I pressed
> > down on the keys. Then it would resume after a few seconds. This would
> > be recrified if I turned the layer from single to dual but I'm looking
> > for a permanent solution.
> >
> > The AN1x hadn't been used in years and I imagine that's part of it. Do
> > you know if there's something simple I can check on the circuitboard?
> > I'm not familiar with electronics at all.
> >
> > Thanks,
> >
> > Alex
> >
> Hi Alex,
> i never had this kind of problem.
> In "poly single" mode you have the full polyphony on the whole keyboard
> and normally you can't miss notes, having 10 fingers as most human
> beings have.
> First try to perform a full factory reset . OK, you'll loose the sounds
> you have in your synth, but on another hand factory sounds are service
> proven.
> Do you have a "battery low" message when you turn your AN1x on?
> Cheers
> J.F.
>
> >
> >
>